![]() If (when!) it falls down, don't be surprised, and don't blame Ikea. ![]() You are depending on a ring of crushed plaster (around the outside of each of your anchors) to hold up LACK plus any books you put on it. ![]() Drywall is made of plaster-of-Paris between two sheets of paper if the paper gets torn, or the plaster gets broken or crushed, the drywall loses all of its strength and basically turns into dust. The other thing: I wouldn't trust those drywall anchors you show in your picture. Many companies make separate versions of their products for the US and for everybody else in the world. I'm not sure what the European standard is, but you can be sure it's in centimetres, not inches! This is why you're extremely unlikely to line up more than one hole. We have a bunch of LACK shelves all over the house, and my fiancee also uses them in her office.Ī couple of things: American construction uses studs spaced "16 inches on center" - this means that the studs are 16 inches apart, measuring from the center of one to the center of the next. The funny thing is I always loved the way these looked. I drilled a pilot hole with the drill bit and then twisted the screw into the wall.Īfter the back plate was completely installed I slid on the shelf, attached it to the back plate with the two small screws that IKEA did supply for this purpose. Because my studs were metal not wood, I had to go back to Pleasant's to buy metal screws that work with wood and metal. The side of the shelf attached to a wall stud does not need anchors. I placed the back plate up and inserted the screw into the anchor and drove it in until it felt secure. Then I just had to twist the anchor into the drywall until it was flush with the wall. I inserted the Phillips Head bit on my screwdriver into the hole of the anchor and pressed the point into the wall. The anchors would be used on the side not attached to a stud. The LACK shelf is actually a shell that is slid over this plate and two small screws attach the shelf to the back plate. I was now ready to attach the back plate to the wall. However, I waited to put the shelves up on a weekend when I would have a whole day to deal with anything else that might come up. After I don't know how many tries, on how many days, I had pencil dots marking some fairly consistent studs. However, no matter how many times I read the directions I kept coming up with different locations for the studs in my wall. I bought the highly recommended Black & Decker BullsEye laser and stud sensor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |